Jump to content

Dynamic Block Stretch


CiCAD

Recommended Posts

I Am creating a DB where i would like to stretch an item from on point and stretch again for half of the and example is i have a slotted panel with 2 rows of slots. 70mm border with a 70mm solid down the center between the slots. the slots being the variable i would like one strect point (two parameters obviously i think!) So As the 70mm solid in the center remains i do not want to stretch from the center out. i would like the slots to stretch the same direction one strecthing half the distance of the other so as to keep them the same distance

 

If you understood all that,,, CAN IT BE DONE???

Link to comment
Share on other sites

Can you post a before and after DWG file? Show what you want to start with and what you actually want it to look like then you're done stretching it. I can't follow what you're trying to do by reading your example.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...