Non Consistent point size

[hyposmurf]

Maybe this a not the best way,but as part of our ipiework layout we use little x to indicate pipework to be removed.Ive used the AutoCAD x points for this,only problem is that I set the point style to 10 and then when I insert the points on polylines of different scale factors the points are different sizes.Is there any way around this as I want the points to be all the same size or would I just be better to produce my own block?

[Flores]

Enter "ddptype" at the command line, and check the "Set size in absolute units" radio button, then enter a positive number such as .25 or whatever.

Flores

[hyposmurf]

Aha rather than the relative units!Didnt notice that,so that would be why my points were chnaging in size relative the scales of my polylines