Jump to content

Create points on figures


rlshound

Recommended Posts

Hello, I am happy to tell you all that I have figured out the last piece of the LDD 2008 field to finish process. I created a figure prefix library and have been importing figures as breaklines. You veterans are probably thinking "What took you so long" but thanks for your help along the way. After this last step its on to Civil 3D...

 

Another question...

 

Can someone please step through the "Create points on Figures" command...I would like to place x,y,z type points along a figure (gutter line...every 10 feet) to create a denser dtm...

 

When I elect the command...it prompts me to enter a point number then to select the figure...ok....it puts the point at the beginning or end of the figure...

Is there a way to evenly space out the points?

 

As always any help would be appreciated

 

Thanks, rlshound

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...