Deleted anchor point command by mistake

[Annlaure]

Ok, so i obviously didn't delete the entire command, but i did mistakenly remove it from the parameter section of the block authoring pallete.

Can anyone help me with any information on how i get it back onto the pallete?

Using Autocad 2011.

If i have not been specific enough please feel free to flame me and i'll get the details you need asap

Thanks in advance for any help provided.

[nestly]

I don't know how to do it directly since it appears the CUI and Block Editor can't be open at the same time, but you can drag the Basepoint Parameter out of the CUI onto the regular Tool Palette, then drag it from the regular Tool Palette onto the Block Authoring Palette. (see video below)

http://www.screencast.com/t/e5J8gmAqHb

[ccowgill]

Capture.jpg you could try getting to it by the attached screen shot as well. We have our acad.cui set to read only by loading an enterprise cui file. Doing this may prevent this from happening in the future.

[Annlaure]

All sorted!

Many thanks for the fantastic help