Jump to content

Rasters being shifted to wrong spot when laser cut

justinpod

By justinpod
in AutoCAD Drawing Management & Output

 Share

Recommended Posts

justinpod Newbie

justinpod

Posted
Posted

Hi, I am using autocad 2011LT to plot to universal laser cutters. We have three different lasers: M300, M360, and V460. When we plot rasters to the M300 and V460, we often notice a shift in the raster cuts from the vector cuts. All of the rasters are always shifted in the same direction and by the same distance (anout 2-3 mm). This shifting started happening about 6 months ago. We have not noticed this shift yet in the M360, but believe it has something to do with the autocad settings. We have cleaned out and reinstalled all of the laser cutter drivers and still have this issue. Has anyone ran into this issue or have any advice?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...