rkent Posted February 4, 2011 Share Posted February 4, 2011 hi all, i am new to this forum.. and found the posts are really helpful.. basically i am a mech design fellow designing mech parts like coupling, brackets etc.. recently i am tasked to draw pipes.. just pipes with 2 or 3 bends at different angles / axis.. so ur assistance needed is in .. (a) how to draw pipes with bend angles in 2d and dimension them.. (b) if possible, pl give some sample dwg files.. thanks in adv.. Here is an example, note the ellipse used to denote 45s going down, for 90 degree ells use a circle broken the same way. The connection points may need to be shown with an X or filled donuts depending on standards, type of joint (weld, screw, solder), etc. 2d pipe example.dwg Quote Link to comment Share on other sites More sharing options...
abc_123 Posted February 5, 2011 Author Share Posted February 5, 2011 thanks...rkent & all,,, Quote Link to comment Share on other sites More sharing options...
isutheparambil Posted August 8, 2017 Share Posted August 8, 2017 Hi Remark, Do you have any lisp that converting plines or lines to a pipe and its fittings format, ie with elbow like... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.