Jump to content

another Oleson village question


Autocadstudent

Recommended Posts

hello spen1973, Remark and Armydude2211 and anyone else whos done this, am starting to do this olesom village. the booklet says set the units to reflect decimals to hundreadth of a foot, and set direction to surveyor's unit.

I set the type to decimal, presicion to 0.0000, type to surveyor's. then set limits to 0,0 and 10000000,10000000 for upper-r corner. But when i try to place a 113.66 feet line from the bench mark or from any point i can't see the line, it ask for the next point and the next point . i noticed that when i place a random line it shows 7 digits. do you know what am doing wrong? Please help Thank you.

Link to comment
Share on other sites

The limits you said you set were 10 Million by 10 Million. In that case a line 113 units long would be practically invisible. I think you need to check your instructions again and verify what the limits should be set at. If you are using feet as the unit of measure, the limits you've set are half the size of the United States. 10 Million feet is nearly 1900 miles.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...