Jump to content

autocad 2011 front top rightside one problem in script making


Concretetablecadman

Recommended Posts

hello everyone i actually have the above views and a full front section done but now that i have done that when i try to use solview to make a full right side section it uses my most previous viewport and i was wondering if any one knew a command for command prompt th switched the vieports that yoou can enter in the command prompt i do have a shortcut using control plus something so a way to use ctrl in script would be handy as well thank you for the help

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...