alijahed Posted March 25, 2011 Share Posted March 25, 2011 Hi All, As you know a simple hinge has 2 parts. One leaf will attach to the door panel and the other leaf attach to the door frame. I have a whole hinge as an assembly file and I have the whole door in another assembly file using the assembled hinge in it. Is there any way to open the door and at the same time that side of the assembled hinge which attached to the door panel rotate as well? Cheers AJ Quote Link to comment Share on other sites More sharing options...
kencaz Posted March 25, 2011 Share Posted March 25, 2011 Hi All, As you know a simple hinge has 2 parts. One leaf will attach to the door panel and the other leaf attach to the door frame. I have a whole hinge as an assembly file and I have the whole door in another assembly file using the assembled hinge in it. Is there any way to open the door and at the same time that side of the assembled hinge which attached to the door panel rotate as well? Cheers AJ Why not just bring in the individual hinge components into the door assembly and constrain them there? KC Quote Link to comment Share on other sites More sharing options...
JD Mather Posted March 25, 2011 Share Posted March 25, 2011 Right click on the hinge sub-assembly and set to Flexible. If you can't figure it out - zip and attach your assembly here. Quote Link to comment Share on other sites More sharing options...
alijahed Posted March 26, 2011 Author Share Posted March 26, 2011 Perfect! Thanks a lot JD. I am getting there... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.