Jump to content

Control the location of a profile in Content Builder


DIW_HDsupply

Recommended Posts

Working on a parametric model to represent a bolt set. I got it all created and realized I don't have any way to constrain the profiles for the bolts.. Any Ideas?

 

I thought it was all constrained, then I used a size other than the 12" I did the modeling in, and noticed the bolts were not in the correct position.

 

see screen shots

first.. at the size I created it.. then modified the bolts diameter.

 

http://dl.dropbox.com/u/20790817/Bolts-Screenshot01.jpg

 

http://dl.dropbox.com/u/20790817/Bolts-Screenshot02.jpg

 

Open to suggestions....

 

We need the parts for automating the BOM..

I know this is unusual..

Link to comment
Share on other sites

I added points closer to the center, dimensioned them, and then made the profiles and constrained the profiles via the coincidet the points with the profile.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...