Jump to content

Recommended Posts

Does anyone know if there is a system variable to keep a stacked fraction with the leading number?

We open the same drawing on different computers at work and on one computer the number will be 21/2 but on the next computer that opens the same dwg the 1/2 will have been bumped down to the the following line. I don't know if this is a problem with the autostack properties, although I can't find anything about that, or if its a problem with the tabs.

I'm completely at a loss and its becoming a problem because if one person opens a project to plot it and it looks fine but the next person opens it and every mtext in the dwg is wrong it becomes very time consuming to fix.

Any help is greatly appreciated! Thank you!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...