Jump to content

2 datum surfaces in 1 corridor


sandiegophil

Recommended Posts

Hello,

 

This is what I am trying to do:

Say I have a 100' alignment.

I create 2 baselines with 1 region each, same alignment, profile and assembly.

One goes from 0+00 to 30+00 and the other from 60+00 to 100+00

(that makes a 30' gap with no feature lines connecting them)

Now what I can't seem to do is make a separate datum surface for each baseline.

I can make one large, single datum surface but it creates datum surface data in the 30' gap I mentioned above. Any and all help and or suggestions are appreciated.

 

Thanks,

Phil

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...