Jump to content

Dimensions next to line while drawing


kjaved373

Recommended Posts

Hello, new to the forum. :D

 

I have recently gotten Autocad 2012 and played around. I am trying to figure out how to make the dimensions of a line that you are currently drawing show up in standard units (feet inches). Right now it shows up as numbers with decimals. I tried DIMSTYLE but couldn't figure out what to change.

Link to comment
Share on other sites

Command: UNITS

 

 

More specifically, UNITS > Length type > Architectural

... and then when you get around to adding dimensions, then you'll go into DIMSTYLE and change "Primary Units" to Architectural as well.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...