Jump to content

Polyline Vertex - Changing Elevation


Recommended Posts

Perhaps someone can advise how to change the elevation of each vertex on a polyline so that each vertex has a different value. The way I attempted this in the past was to click on polyline, click properties and give each vertex the required elevation. However when I looked back at the values I noticed that every vertex had the same value as the last elevation value entered. is it something to do with ensuring polyline is 3D? Many thanks.

Link to comment
Share on other sites

The normal polyline can only have one z value throughout. That is how it is :shock:

 

What you need is the 3D polyline, and I not sure whether LT can cope with 3D

Link to comment
Share on other sites

I think by writing the question I discovered the possible annswer but thanks for confirming and my version does have a 3D line though not on the toolbar. Cheers.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...