Jump to content

Polygonal Viewport synced with View in SSM?


tzframpton

Recommended Posts

When I use the SSM and use the "Place on Sheet" command to create the Viewport from the MS View DWG file, it comes in only as a rectangular Viewport. I tried to see if there's a way to draw a Polyline and select it as a MS View but I don't think that's possible.

 

Any way to do this without breaking the link between the View DWG and the Sheet DWG? Thanks in advance.

 

8)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...