Extruding Faces on Tapered Angles

[Hogfan]

I have a arc that is about 21.5 radius and .5 in width. My problem is that it is going on a bench that i have made and the corner piece needs to be cut out and i am trying to figure how to make this line look like an actual piece. Does this make sense to anyone? i can extrude the piece to 21 inches tall, but then i need it tapered back to fit this bench were making.

[Jack_O'neill]

Not sure I'm following what you're trying to do. Is the curved bit going to be over the desk like a roll top cover or am I lost?

[Hogfan]

Did you look at the pdf? It is going up against the back. That is what it is, a back for this bench, then they will put padding and cover it. Sorry the pics may not do it justice. i can show an overall view of the bench if that would help.

[nestly]

I'm also having trouble visualizing the part.

[Jack_O'neill]

Ok..duh...you said bench, and I thought "workbench". You're sitting on this, right?

[Hogfan]

Yes this is a sitdown bench, i will try to get a plan view of this, brb.

[Jack_O'neill]

Ok...gotcha now. Couple questions...the cushions for the seat and the back in the corner, are they attached to each other or separate pieces?

[Hogfan]

The cushion will be seperate and the back is made of benda grade plywood.

[dshowalt]

Are you wanting to do a Profile and then a Sweep with rails

[Hogfan]

Possibly so , this is embarrassingly over my head. If you look at the plan view of the arc, i need it to be 21.5 tall and angled back at 9 degrees also. I have never taken any AC lessons, I am self taught mostly other than what i get from here and a few other friends. Sorry i cant answer that question with a positive response. The software i use is AC based and so i usually just modify parts through the program, except the few instances like this. Thanks.