decals disappearing when scaling using derived part

[rogle]

Hi

Im trying to create a derived part so i can scale up a part but every time I do the decals that I have on the part disappear and cannot be found in the design tree. is there any way round this?

Thanks

[rogle]

Also iv noticed that they do not show up on showcase when im trying to render assemblies. is there maybe another way of getting a .jpeg image onto a part so it would show?

[rdharvey]

http://www.autodesk.com/us/showcase/...012SP1-enu.pdf

[rogle]

Iv installed the update and its still not showing the decals

[vweavers]

Hi

Im trying to create a derived part so i can scale up a part but every time I do the decals that I have on the part disappear and cannot be found in the design tree. is there any way round this?

Thanks

I'm now running into this as well. I first had problems with decals in assemblies at all- then I discovered putting the .bmp file in the same folder as the .ipt allowed the assembly to bring in the decal.

Now, though the decal is disappearing when making an iPart - regardless of where the .bmp file is. Unless there is another answer out there, I think the only solution is to create separate parts and assemble them?