19cruthik68 Posted September 26, 2011 Share Posted September 26, 2011 Try to check the image, porblem regarding the UCS. I will modify some of the file that was given to me, when I open the file, the axis is like this (the one drawn below, with the yellow X and Y axis), so i tried to change it using the UCS command, so I already changed the axis (same as the drawing below, the original axis.) BUT!, when the axis is already changed, the cursor turns like that (also see the image below), so How can I change my cursor? Who knows about this one, need your help, thanks Quote Link to comment Share on other sites More sharing options...
ReMark Posted September 26, 2011 Share Posted September 26, 2011 Have you tried setting SNAPANG to "0"? Quote Link to comment Share on other sites More sharing options...
Sphiinx Posted September 26, 2011 Share Posted September 26, 2011 Also make sure the Snap isnt set to ISO Quote Link to comment Share on other sites More sharing options...
19cruthik68 Posted September 27, 2011 Author Share Posted September 27, 2011 Thanks for the SNAPANG command, i forgot that command already. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.