Jump to content

Problems plotting - lineweights too dark(both pdf and printer)


DanCorbett1

Recommended Posts

Hi,

 

I'm having problems with lineweights. It shows up too dark whenever I plot to both pdf and the printer (Kyocera KM-2560 KX). Ive tried adjusting the ctb file (changing thicknesses of colours) but to no avail. This problem does not occur for my colleagues, with exactly the same ctb file. So is it a general autocad setting problem?

 

Any help would be greatly appreciated,

 

Daniel

Link to comment
Share on other sites

we had this problem on random since long time and i recently figured out the reason. it could be the same for u.

 

check the unit of paper size u select while printing because our drawing was in inches and if we select A3 size it useto print very dark because A3 for standard printer settings in mm so if i selct 11x17 as paper size, it started printing fine...........

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...