metsj373 Posted September 30, 2011 Share Posted September 30, 2011 What are the commands to make a tangent line from one circle 90 degrees to the tangent line of another circle? Quote Link to comment Share on other sites More sharing options...
Andy Leach Posted September 30, 2011 Share Posted September 30, 2011 Have you tried using the osnaps? F3 switches them on and off and DS (draft settings) on the command line and then object snap tab, then pick the snaps you require. Hope this helps. Andy Quote Link to comment Share on other sites More sharing options...
CyberAngel Posted September 30, 2011 Share Posted September 30, 2011 A picture would be very helpful in this situation. If you want to draw a line tangent to two circles, you can use the Tan snap for both of them as M. Leach suggests. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.