muck Posted October 7, 2011 Share Posted October 7, 2011 AutiCAD 2010 I have been making blocks Annotative by using block Editor. I would open block Editor and change the block property to annotative. When I do that I notice that the block's attributes become unreadable. The block's attribute appears to become so squished up the I can't read it. I have tryed to change the attributes width to make it readable but that does not work. Any solutions to this problem? Thank you, Quote Link to comment Share on other sites More sharing options...
SLW210 Posted October 7, 2011 Share Posted October 7, 2011 Are the attributes annotative? Quote Link to comment Share on other sites More sharing options...
muck Posted October 11, 2011 Author Share Posted October 11, 2011 How do I check to see if an block attribute is not annotative? I don't think the attributes are annotative but I guess I need to confirm that they are not annotative in a block? Thank you, Quote Link to comment Share on other sites More sharing options...
irneb Posted October 11, 2011 Share Posted October 11, 2011 Well, you can "select" the attribute of a block reference by holding down the Ctrl key. Or inside the block definition (BEdit) you can select the AttDef normally. Then in the properties palette (Ctrl+1) should be an "Annotative" property - if it's "Yes" then it's annotative. If you edit the AttDef inside BEdit, remember to BAttMan / AttSync to update the existing insertions. BTW, the word "squished" in your OP makes me think: are these attributes perhaps set as justified to Fit / Aligned? That might cause hassles with annotative. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.