zyhin Posted October 10, 2011 Share Posted October 10, 2011 Hi All, I currently have a dynamic block with visibilty states that allow me to use 3 different hinge set ups. These types are 2 x 50mm which is for doors up to 312mm, then 2 x 80mm hinges for upto 1000mm then 3 x 80mm hinges for everything after that. These are just standard pintal hinges not that that should make a difference. What I am trying to do is, just have one set of hinges that depending on how far I stretch them out will change to suit the requirements. I am new to dynamic blocks so dont know it this can be done with it. I also have a fair bit of VBA knowledge, but only in excel. Never attemped to use it in Autocad. Any help would be great Zyhin Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.