bass_mark00 Posted October 12, 2011 Share Posted October 12, 2011 Does anyone have a solution to this?: The path array in 2012 is a very useful addition but I can't crack a solution to creating an array around an elipse (like chairs around a board room table). The only way I've found it to work is to break the elipse and then join up the gap, essentially creating a closed eliptical arc. This gets a result but it seems a very scrappy work-around to something which should simply work. Any suggestions? Thanks Quote Link to comment Share on other sites More sharing options...
eldon Posted October 12, 2011 Share Posted October 12, 2011 In a previous thread, I think that it was discovered that the block was arrayed relative to the base point of the ellipse, which seemed to be at the right hand end of the horizontal axis. Perhaps a screen shot to show where your block is in relation to the ellipse would help, or post a drawing. Quote Link to comment Share on other sites More sharing options...
SLW210 Posted October 12, 2011 Share Posted October 12, 2011 See the "Similar Threads" at the bottom of this page. lllllllllllllllllllllllllllllllllllll vvvvvvvvvvvvvvvvv Quote Link to comment Share on other sites More sharing options...
bass_mark00 Posted October 12, 2011 Author Share Posted October 12, 2011 Thanks for the advice, the solution is to start the array from the first point of the ellipse axis. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.