Jump to content

Hatch boundary problem


MisterJingles

Recommended Posts

CyberAngel - Thanks. I right clicked the Polyline, closed it, properties now say "Closed - Yes", and yet I still get the same error.

Any other ideas?

Link to comment
Share on other sites

Try increasing the HPGAPTOL setting. I get this a lot with 2008 when I know darn well that the polyline is closed but it won't hatch.

 

How far is the area you want to hatch from the drawing origin (0,0,0)? Try moving it closer to the origin too.

Link to comment
Share on other sites

Bullseye - Unfortunately the object is very long and narrow, its not possible to do that.

 

Supercad - I moved it closer to the drawing origin but still no joy, but increasing the HPGAPTOL fixed the problem.

 

Annoying! Thanks everyone.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...