Registered forum members do not see this ad.
I have created my own terminal block icon which i can access from the panel icon menu.
The problem i am having is that when creating my terminal strip from my schematic by selecting the "terminal strip editor" and i select from the catalogue list my terminal it will not show the terminals in the "layout preview", it will show the tabular terminal strip (table object) and even the jumper chart if i select this in layout preview.
I noticed that when in "layout preview" in the terminal strip editor, on my command prompt it tries to load my terminal blocks but it says the following:
Block FPT_DKT4-35 refrences itself ( where FPT_DKT4-35 is my block)
I sometimes get a error message "Error loading Hedi Module"