blackeagle1245 Posted February 4, 2012 Share Posted February 4, 2012 Is there any kind of pipe sizing in mep?. Quote Link to comment Share on other sites More sharing options...
tzframpton Posted February 5, 2012 Share Posted February 5, 2012 HVAC duct only as far as I know. Quote Link to comment Share on other sites More sharing options...
blackeagle1245 Posted February 6, 2012 Author Share Posted February 6, 2012 I think the same. But then what does size plumbing line button in analyze tab do?. Quote Link to comment Share on other sites More sharing options...
tzframpton Posted February 6, 2012 Share Posted February 6, 2012 I think that's for the 2D single-line Plumbing Objects, not Piping Objects. Just for informational purposes. Quote Link to comment Share on other sites More sharing options...
blackeagle1245 Posted February 6, 2012 Author Share Posted February 6, 2012 If we draw plumbing 2D, then can mep calculate the size of pipes? Quote Link to comment Share on other sites More sharing options...
tzframpton Posted February 6, 2012 Share Posted February 6, 2012 I don't know, I've never done it. I'm assuming it might be much more work than getting out the good 'ol calculator anyways. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.