Jump to content

Tube/Pipe Run?


DoctorDrake

Recommended Posts

Having trouble figuring out how to draw 90's and 45's using just inventor (not professional.) I am trying to draw a drain on a vertical seperator. The drain is 5 inches long and makes a 90 degree bend sideways. the radius of the bend is 4 3/16" (4.1875".) drain bend.jpg i have attached the autocad dwg of what i am trying to accomplish. thank you for your help

Link to comment
Share on other sites

  • 5 months later...

Did you ever find a solution for this? I am also wondering how to do it in Inventor without Inventor Professional. I can do it in AutoCAD using offset in 2D or revolve and union in 3D but I'd like to learn how to do it in Inventor.

Link to comment
Share on other sites

For now I just drew it in ACAD and imported it into Inventor.

 

Do you still need to know how to do it the easy way (in Inventor)?

Link to comment
Share on other sites

drain 90.ipt

 

This is the easy way to do it in Inventor.

 

Or at least, it's an easy way. You'll have to change the position of the circles - I don't think the alignment is quite the way you wanted, but the principle is the same.

Link to comment
Share on other sites

  • 3 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...