Jump to content

girts as component of wall section?


WillP

Recommended Posts

Hi all,

I'm a longtime AutoCad user, new to Architecture. I'm trying to create a wall style that is 3" brick veneer, 1" airspace, 3" ins. panel, 10" horizontal girt, 3 5/8" stud wall and 5/8" drywall. Should I specify the girt as a component in the wall" It's not continuous, there's one at, say 6' o.c. vertically. Or should this 10" be an "airspace". Also don't quite get the "edge offset" spec, I'm just trial & error-ing my way thru it.

Thanks, great resource here!

Will Patton

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...