Jump to content

Roof, one floor, 2012 REVIT Architecture


CADLee

Recommended Posts

Can anyone help me attach a roof to a one story house. The ceiling height is 9ft. I am still learning and only have done a 2 story house. Can anyone please help me with this.

 

Many THANKS

Link to comment
Share on other sites

  • 3 weeks later...

Shouldnt be much different than when you did the two story. Just set your plan view to the first floor level, select roof by footprint if applicable, select your overhang distance and check or uncheck defines slope, select all four walls and then click on the green check mark. Then say yes to attach the walls to the roof. There is a book out called Residential Design using Revit 2012 by SDC publications that is VERY good. Their site is http://www.SDCpublications.com. It taught me quite a few things.

Link to comment
Share on other sites

Place the roof on the 9' level. (Level 2 or Roof) and follow dak instructions above. I agree, the Residential Design book is a good.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...