Jump to content

Autocad 2013 Circle


Recommended Posts

Hi , cant draw a tan ,tan, radius circle , between 2 splines, it doesn't show any tangent point on a spline ? between two circles or 2 lines, no problems ...

 

Autocad Architecture 2013 64,

Thanks!

Link to comment
Share on other sites

I Drawed 2 splines from top , so they must be coplanar, or not? If I remember, 2012 had nu such problem...

same behind ellipses...

Link to comment
Share on other sites

If your spline does not show tangent points, then you have to convert it to a polyline. In my version of AutoCAD, that can be done by using FLATTEN, even if everything is already at z=zero. Your version may have some other means of converting.

Link to comment
Share on other sites

Flatten is an Express Tools command. You probably can convert the Spline directly, but I cannot help you there.

 

I personally think that Splines can be a menace, and I would always use a curve fit polyline.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...