Jump to content

Massive help with piston project (challenge)


midorizk

Recommended Posts

here is the problem that im supposed to draw

 

in the picture in the attachment, the mechanism for a front end loader is shown in fiqure p 15.9. the specifications call for the boom to elevate through 74 degree from the position shown. Find the piston travel required for the boom cylinder X to the produce this elevation. at the upper position the bottom of the bucker is to slope downward at 50 degrees to dump the contents. what piston travel is required for the bucket cylinder Y to accomplish this operation? use a scale of 1:10

 

you will find the picture in this page

http://www.cadeverything.com/help/showthread.php/7077-Massive-help-with-piston-project-(challenge)

Link to comment
Share on other sites

I think your project is better suited for Inventor rather than AutoCAD.
probably but easiest way is to ask somebody else to do it for you! :rofl:

 

Note to OP - not aimed at you but we do get a lot on here making little if any attempt to do any of it themselves.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...