Jump to content

MEP broken?


dumfatnhappy

Recommended Posts

trying like hell to cut plans and sections but no joy. I go to an older drawing and try to *edit* an existing section and I don't get the full drop-down to re-select objects, etc... just modify commands, etc. It's like all the MEP intellegence is just gone! even on new dwg's (qnew). I tried to repair the installation but still nadda.... can't figure out what went wrong/where. This is a network license so a re-install is a pain. Any ideas what's going on? :unsure:

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...