dumfatnhappy Posted April 26, 2012 Share Posted April 26, 2012 trying like hell to cut plans and sections but no joy. I go to an older drawing and try to *edit* an existing section and I don't get the full drop-down to re-select objects, etc... just modify commands, etc. It's like all the MEP intellegence is just gone! even on new dwg's (qnew). I tried to repair the installation but still nadda.... can't figure out what went wrong/where. This is a network license so a re-install is a pain. Any ideas what's going on? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.