Jump to content

Updating title blocks


pjmac

Recommended Posts

i have a standard title block i use for all my drawings. I have recently updated that title block (tolerances and such). Is there a way to update this in all of my drawings without manually typing the new info in each of the pre existing drawings,

Link to comment
Share on other sites

Yep!

 

Copy that title block into a new blank drawing based on your current template, then save it again as a template over your existing one. This sets it for all your future new drawings.

 

For the existing drawings, once you open it up and find that you've got an out of date title block, just open up a new blank drawing - since you've already saved the new block to your template - and then copy-paste either just the new title block itself over to the old drawing, or you can bring the whole Drawing Resources folder over. This will bring sketch symbols, borders, etc., as well. I wind up doing this a lot - over the last 10 months or so I've been constantly adding new little automations and sketched symbols to my template, as well as title block changes, so I just bring the whole thing over in one shot.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...