Jump to content

MEP 2011 - Build Ribbon


Ravenstown

Recommended Posts

After I had to reboot my file the "build" panel now shows the mechanical options (i.e. duct, pipe, etc...) instead of the Electrical options (i.e. conduit, cabletray....) that were shown before the reboot. I can get the electrical tool pallete to show but can not get the "build" panel back the way it was. How do I change what is displayed there?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...