hekri Posted May 1, 2012 Share Posted May 1, 2012 Hello guys, I need help with a drawing in Inventor (2010). My problem is this: I have to make a section view of a part but I don't wanna section the whole part cause I need to dimension it, I just have to make partial section of the part, i want to show the hole down there. I have attached a pdf file of the part. This is how it should look. (it's drawn in AutoCAD). If someone could take a look at it. Thank you in advance. P.S I apologize for my bad English, it's not my native language. 123.pdf Quote Link to comment Share on other sites More sharing options...
MarkFlayler Posted May 1, 2012 Share Posted May 1, 2012 For what you want here, you need to create a Break Out view. Select your view and then select to Create a New Sketch Use Project Geometry to locate your cutout shape on your view Finish the Sketch Start the Break Out command Select your sketch and depth options. Quote Link to comment Share on other sites More sharing options...
hekri Posted May 1, 2012 Author Share Posted May 1, 2012 Thanks for your reply. I'll try it now. Quote Link to comment Share on other sites More sharing options...
hekri Posted May 1, 2012 Author Share Posted May 1, 2012 Thanks again, MarkFlayer it worked just as you said. Have a nice day. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.