rickh Posted June 1, 2012 Share Posted June 1, 2012 Greetings, If I have XDWGFADECTL set to something other than 0 and set WHIPARC to 1, the arcs in xrefs show up without any fading. Does anyone have a thought for a solution to still have those xref arcs apply the fading with Whiparc set to 1? Thanks. Quote Link to comment Share on other sites More sharing options...
rkent Posted June 1, 2012 Share Posted June 1, 2012 Why do you need WHIPARC set to 1? Quote Link to comment Share on other sites More sharing options...
rickh Posted June 1, 2012 Author Share Posted June 1, 2012 Hi rkent, it's not mandatory to set it to 1, just preferred. Mainly, it just cuts down on the regens. I do a lot of detail work, so I am moving back and forth from large land plan views down into tiny little inches. I was just curious if anyone knows of a way to make these two settings work together; otherwise, I'll just leave whiparc off....or turn of the xref fade.... Quote Link to comment Share on other sites More sharing options...
SLW210 Posted June 4, 2012 Share Posted June 4, 2012 AFAIK only solution is WHIPARC=0 Quote Link to comment Share on other sites More sharing options...
rkmcswain Posted July 1, 2014 Share Posted July 1, 2014 FYI: It's still broken in 2015 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.