Registered forum members do not see this ad.
When I open my SW drawing, the entire model is visible and everything looks great. However, when I go to preview the plot or even plot the drawing, only part of the assembly is visible (the part that shows all the electrical wire routing) and the rest of the assembly dissappears (the transformer).
This is not the first time I have run into this issue. What I have done in the past to resolve it is delete the model view out and re-insert it, and it seems to be fine after that but I should not have to do this each and every time.
I am using SW 2009 Premium, on a XP-64bit Dell Precision T5500, Intel Xeon CPU E5620 @ 2.40GHz, 6GB RAM, NVIDIA Quadro FX 3800.
Any suggestions would be greatly appreciated! Thanks!