KarolR Posted June 23, 2012 Share Posted June 23, 2012 I made a complex sketch, and want to extrude. When i want to select the whole sketch, i position the mouse on the upper left of the screen and drag down and right, but no window is created. And i cannot add segments to the selection, even with pressing SHIFT, because immediately after the first is selected, it is extruded. Third question: you see on the picture i attached that some segments (in red) are connected. how can i connect all the sketch together, so when i will select it everything is selected. Thanks-Karol Quote Link to comment Share on other sites More sharing options...
JD Mather Posted June 24, 2012 Share Posted June 24, 2012 Use Feature Patterns rather than Sketch Patterns. Your sketch is missing coincident constraints - run the sketch doctor. Forget window selection of this for extruding - that would not be correct way. If the sketch was correct it would take only one click in the enclosed area (if Inventor didn't automatically detect the close area). Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.