Bryan316 Posted November 29, 2017 Share Posted November 29, 2017 Nope, found nothing specific to the sizing of reducers. This has been a month long investigation, and none of us have found anything like that. Even for the Grooved routing preference, these reducers are about 5 times larger than all the other schematic symbols. Quote Link to comment Share on other sites More sharing options...
tzframpton Posted November 29, 2017 Share Posted November 29, 2017 I do believe there is a way. I remember figuring this out approximately 8 years ago when I used the program. It's just been way too many years for me to remember exactly how I figured it out. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.