Jump to content

Question about Boss Height?


souptech

Recommended Posts

Help!

 

I have a simple 2D drawing that I have to convert to 3D and the drawing states that: Thickness: 0.5 & Boss Height: 0.25. I dont know if the height of the circles dia. 1.0 and 2.0 are set at 0.25 or is this added onto the thickness 0.5. Thank you in advance for any help.

 

Base Plate.jpg

Link to comment
Share on other sites

A "boss" is a raised portion (usually circular), so I believe the part is .5 thick with an additional .25 for the boss.

Boss.gif

Link to comment
Share on other sites

That is how I would read that too. :thumbsup:

nestly, watching your videos makes ME want to learn autocad too,

then I remember that I already know it, after the credits are run

as I am filing out of the theater. :beer:

Link to comment
Share on other sites

  • 2 years later...
I have the exact same problem and didn't know what boss height was either. Thanks for the help almost 3 years later. :D
Well, OK, but how tall is your bush? :rofl:(see post #4,) I'm not poking fun at you, it's just that post #4 was hilarious.
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...