Problem using Autotrack with remote desktop connection

[MrTapir]

We have one specific cad machine in the office with Autotrack. Rather than keeping on switching from my computer and this one, a colleague said why dont I try remote desktop connection. I have done this, but when I open the Cad machine on my own computer and open Cad and try to get the vehicle library up it comes up with this error box:

"No licence manager found. Please ensure you are connected to the network, the licence manager is switched on, active and that your settings are correct. Would you like to review your network settings?"

I can use autotrack fine on the specific CAD machine so I'm confused. The guy that deals with IT says it should work fine. Anyone had any similar issues and found a fix?

Thanks, RIch

[Organic]

I'm guessing the security of AutoTrack blocks that somehow. It is possible to setup a network license for Autotrack where you would have it installed on both computers, although only one of them can use it at any one point of time, so perhaps look into that instead.

[MrTapir]

Yes I thought as much, although my colleague said it should be fine as you are just porting pictures over to the other computer, I wasnt so sure. Yes your second point is what I am trying to get done, and then I just have to go and get the dongle. Thanks for the reply