JillAW Posted August 17, 2012 Share Posted August 17, 2012 Hi... I'm working with Inventor 2011. I received a part file from someone, and notice that when in Sketch mode, the part is not aligned as I want it to be. That is, the horizontal and vertical lines of the sketch are not aligned with the horizontal and vertical lines of the grid. As well, when in Model mode,the View Cube is not aligned with the part as I want it to be. The "Front View" that the cube calls out is not orthagonal in relation to the part. I can think of a few ways to address these problems, but I would suggestions as to what the most efficient ways might be. I can attach a file if my question is not clear. Thanks! Quote Link to comment Share on other sites More sharing options...
JD Mather Posted August 17, 2012 Share Posted August 17, 2012 ...I can attach a file if my question is not clear. Attach the file here. Quote Link to comment Share on other sites More sharing options...
psylencer Posted August 24, 2012 Share Posted August 24, 2012 A little lateral thinking should get the job done. Firstly open the sketch. Find a corner point of your sketch and draw a horizontal line extending from it. Next use the dimension tool to find out what angle the line that should be horizontal is in relation to the line you have just drawn ( use the copy command if it is a long decimal. )Next use the modify > rotate command. Select a box around the entire sketch, next select the first corner point from before as the center point. Then just paste the angle into the angle box. Note you may have to make the angle negative , or use a little addition ie. 90 + 7.5564445 depending on how you took the original dimension. In terms of model view, just rotate the view how you like, right click the home icon in the corner of the view cube > set current view as > front. Hope this helps Quote Link to comment Share on other sites More sharing options...
JillAW Posted September 11, 2012 Author Share Posted September 11, 2012 A belated 'thank you' for your responses. Psylencer-- this did help! But a lingering question remains... (next post) Quote Link to comment Share on other sites More sharing options...
JillAW Posted September 11, 2012 Author Share Posted September 11, 2012 Let's say I get a part file from someone (please see attachment) and I want what the view cube is calling 'front' to be orthagonal to the 'front' of the model (see attached). That is, I want 'front' to be a square-on, orthagonal view. How best to align the model to achieve this? Example_J1.ipt Quote Link to comment Share on other sites More sharing options...
JD Mather Posted September 11, 2012 Share Posted September 11, 2012 Step one Step 2 Quote Link to comment Share on other sites More sharing options...
JillAW Posted September 11, 2012 Author Share Posted September 11, 2012 I was unaware of the 'View Face' command (though embarrassingly, the icon's right in front of me). THANK YOU! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.