Jump to content

Help mitering a ceiling cornice.


cbsmiley

Recommended Posts

how would you create a miter for the shown mouldings? the profile of the moulding is shown on the left. The moulding is a cornice for an interior room, pictured from below (reflected ceiling plan).

Thanks in advance for any help.

miter help.jpg

miter help.dwg

Link to comment
Share on other sites

This is a nice detail, there are no dust accumulating surfaces on it.

There are a bunch of different ways to do this.

I opted to use the SLICE command, and used a circle as my cutting OBJECT.

 

In retrospect, having seen ReMark's approach, I would caution against bothering

to do it this way, unless you are really keen on wasting time and energy! :beer:

It really just takes a minute to do it that way, but that is still about 30 seconds wasted,

which adds up at the end of the week.

miter help.dwg

slice with an object.JPG

Edited by Dadgad
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...