Jump to content

Autocad2006 3Dorbit


stuarthamson

Recommended Posts

Hi there

 

Just started a new job today and it's working on 2006 it's like a step back in time from 2011.

 

I'm tring to set up my middle button 3dorbit on my mouse and it's totally stumped me, anyone got any ideas or can point me to a thread where i can sort it?

 

I've used CUI and setup my button3 to ^P'_3DORBITTRANSPARENT ^P

but this hasn't worked just says unknown command.

cheers

Link to comment
Share on other sites

Aren't you supposed to also be pressing the Shift key? It is Shift+Middle mouse button.

 

Did you set the Command Display Name to 3DORBITTRANSPARENT in the CUI?

Link to comment
Share on other sites

Welcome to the forum. :)

The usual way is to hold down the SHIFT key and also hold down the mouse wheel, at the same time, but I am reasonably sure you already know that.

Link to comment
Share on other sites

I am not familiar with that command, but if you want a command to work in transparent mode use

 

'3dorbit

 

Note the single quote mark in front of the command.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...