Jump to content

Problem with extrude


shwell

Recommended Posts

Hello, I've created a .5cm radius x 12cm height cylinder that I want to hollow out via extrude (to create a syringe body). To do this the cylinder is created with above dimensions and 12 side. An inset by polygon followed by an extrude by polygon doesn't seem to work. The attached picture shows what's going on?? Any clues. It doesn't seem to be a problem with larger diameter cylinders.

Extrude Problem.jpg

Link to comment
Share on other sites

The only thing I can think about that is that you must be trying to inset by too large an amount. If it works ok with larger objects, why don't you create the object at 2x the size and then scale it down when you're done?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...