Jump to content

3D Section Views with Alibre


Niablo

Recommended Posts

I'm using Alibre Design 2011, and I have an assembly of a wind tunnel. I have created a 3d section view of it in the assembly work area, but I cant figure out out to get the same 3d section view to show in a Drawing. I can get 2d section views but I can't get a nice isometric section view. Any help?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...