Jump to content

Another Lesson Request


CADLee

Recommended Posts

I remember when I was at Penn Foster there was a lesson that involved drawing rims or hubcaps. Although this was in 2006 and the lesson was for hand drafting and not doing them on CAD. I was still wondering if anyone might have a copy of these. I Would like to try them again.

 

Any help would be appreciated.

 

Thank You.

Link to comment
Share on other sites

Can't help you there. All the projects I have instructions for were CAD related. I'd check the Student Question forum see who is currently posting questions and send them a PM.

Link to comment
Share on other sites

2D or 3D?

 

Grab a tape measure (don't worry about getting precise measurements) sketchpad and pencil and head for the parking lot.

Come back here to ask questions when you run into trouble.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...