Jump to content

Sphere won't traject down ramp


dearprudence101

Recommended Posts

Hello all,

 

I've created a simple room with a sphere that rolls behind an occluder on a ramp. The ramp is made from extruding a line. When I use Trajectory----"conform from" and try to select the line, it doesn't seem to recognize it. In other words, the sphere is not conforming to the extruded line.

 

I'm not sure what's going on, because if I create a simple line, the sphere will traject down it. If someone could take a look and figure it out, it would be a huge help.

 

Thanks :D

 

Box3.max

Link to comment
Share on other sites

I don't have 2013 so I can't open your file, and I'm no expert on animation, but I believe you have to use a spline as your animation path, not an extruded line.

 

Maybe this tutorial might help:

Link to comment
Share on other sites

Path constraint = profit

 

typically you will have to reverse your initial position values

0-100

 

 

0 being the start

100 being the end point.

Link to comment
Share on other sites

  • 4 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...