Cadflock Posted April 30, 2013 Share Posted April 30, 2013 when I try to use rulesurf between 2 circles on an angled plane, the surface twists instead of drawing a cylinder. Any suggestions?? Quote Link to comment Share on other sites More sharing options...
ReMark Posted April 30, 2013 Share Posted April 30, 2013 I'm assuming the circles have different diameters. Have you tried the LOFT command? Can you attach a copy of the drawing to your next post? Quote Link to comment Share on other sites More sharing options...
JD Mather Posted April 30, 2013 Share Posted April 30, 2013 Is there a reason you are using rulesurf rather than one of the more modern tools (post r2007)? If you really really really want a cylinder (cut at an angle) I think you will need to extrude or revolve and then slice or subtract. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.